Command Reference Guide

306 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set dap auto Creates a template for automatic configuration of Distributed MAPs.
Syntax —
set dap auto
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — Table 65 lists the configurable template parameters and their
defaults. The only parameter that requires configuration is the template
mode. The template is disabled by default. To use the template to
configure Distributed MAPs, you must enable the template using the set
dap auto mode enable command.
The template uses the default radio profile by default. You can change
the profile using the set dap auto radio radio-profile command. You
can use set dap auto commands to change settings for the parameters
listed in Table 65. (The commands are listed in the “See Also” section.)
Table 65 Configurable Template Parameters for Distributed MAPs
Parameter Default Value
MAP Parameters
mode disabled
bias high
upgrade-firmware
(boot-download-enable)
enable (YES)
group (load balancing group) none
blink
(Not shown in display dap config
output)
disable
Radio Parameters
radiotype (type)
(Applies only to single-radio MAP
models)
11g
(or 11b for country codes where
802.11g is not allowed)
mode enabled