Command Reference Guide

288 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
id=0x28f10158a47f0408 ram=33554432
s/n=0332600444 hw_rev=A3
Uptime: 21 hours, 27 minutes, 51 seconds
Radio 1 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:94, ssid: private
The following command displays the status of a directly connected MAP:
WX1200# display ap status 1
Port: 1, AP model: AP2750, manufacturer 3Com, name: MAP01
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x28b08a1e047f1d0f ram=33554432
s/n=0333000288 hw_rev=A3
Uptime: 3 hours, 44 minutes, 28 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 15
base mac: 00:0b:0e:00:d1:00
bssid1: 00:0b:0e:00:d1:00, ssid: public
bssid2: 00:0b:0e:00:d1:02, ssid: employee-net
bssid3: 00:0b:0e:00:d1:04, ssid: mycorp-tkip
Table 57 describes the fields in this display.
Table 57 Output for display ap status
Field Description
DAP Connection ID for the Distributed MAP.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
Port WX port number.
Note: This field is applicable only if the MAP is directly
connected to the WX switch and the WX switch’s port is
configured as an MAP access port.
IP-addr IP address of the MAP. The address is assigned to the MAP
by a DHCP server.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.