Command Reference Guide

display {ap | dap} status 287
display {ap | dap}
status
Displays MAP access point and radio status information.
Syntax —
display ap status [terse] [port-list | all [radio
{1 | 2}]]
Syntax — display dap status [terse] [dap-num [radio {1 |
2}]]
 terse — Displays a brief line of essential status information for each
MAP.
 port-list — List of ports connected to the MAP access point(s) for
which to display status.
 dap-num — Number of a Distributed MAP for which to display status.
 all — Shows status information for all directly attached MAP access
points and all Distributed MAP access points configured on the switch.
 radio 1 — Shows status information for radio 1.
 radio 2 — Shows status information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. True base MAC addresses of
radios are displayed in MSS Version 3.2. Previously, the base MAC
address displayed for a radio was the true base MAC address plus 2. Note
that a radio’s base MAC address is also used as the BSSID of the first SSID
configured on the radio. In Version 4.0, added terse, display dap status:
all, new field for fingerprint, and added MAP-WX security status to State
field. Note: the fingerprint field and security state apply to the display for
Distributed MAPs only.
Examples — The following command displays the status of a Distributed
MAP:
WX4400# display dap status 1
Dap: 1, IP-addr: 10.2.34.56 (vlan 'default'), MAP model: AP2750,
manufacturer: 3Com, name: DAP1
fingerprint: b4:f9:2a52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr