Command Reference Guide

286 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command displays information for MAP
access point group loadbalance1:
WX1200# display ap group loadbalance1
Load Balance Grp Port Clients Status Refused
---------------- ---- ------- --------- -------
loadbalance1 1 1 Accepting 0
loadbalance1 6 6 Refusing 2
Table 56 describes the fields in this display.
See Also
 “set {ap | dap} group” on page 313
Table 56 Output for display ap group
Field Description
Load Balance Grp Name of the MAP access point group.
Port WX port number.
Clients Number of active client sessions on the MAP access point.
Status Association status of the MAP access point:
 Accepting — The MAP access point is accepting new
associations.
 Refusing — The MAP access point is refusing new
associations.
Refused Number of association requests refused by the MAP access
point due to load balancing. MSS resets this counter to 0
when the WX switch is restarted, MSS is reloaded, or the
access point is removed from the group.