Command Reference Guide

display {ap | dap} config 279
See Also
 display dap connection on page 294
 display dap global on page 295
 display dap unconfigured on page 297
 display radio-profile on page 298
 set dap on page 77
 set port type ap on page 87
 set {ap | dap} bias on page 310
mode Radio state:
 Enabled
 Disabled
channel Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
auto-tune
max-power
Maximum power level the RF Auto-Tuning feature can set on
the radio.
 The value default means RF Auto-Tuning can set the
power up to the maximum level allowed for the country
of operation.
 A specific numeric value means you or another
administrator set the maximum value.
auto-tune
min-client-rate
Minimum data rate the radio must maintain for associated
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.
auto-tune
max-retransmissions
Maximum percentage of packets that can be retransmitted
by a client before RF Auto-Tuning increases power.
Note: Only packets that are received twice by the MAP are
counted as retransmissions. If a client retransmits a packet
but the MAP receives only a single copy of the packet, the
packet is not counted as a retransmission.
Table 52 Output for display ap config (continued)
Field Description