Command Reference Guide

278 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Table 52 Output for display ap config
Field Description
Port WX port number.
Note: This field is applicable only if the MAP is directly
connected to the WX switch and the WX switch’s port is
configured as a MAP access port.
DAP Connection ID for the Distributed MAP.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
Serial-Id Serial ID of the MAP access point.
Note: This field is displayed only for Distributed MAPs.
AP model MAP access point model number.
POE PoE state on the WX port:
 Enable
 Disable
bias Bias of the WX connection to the MAP:
 High
 Low
name MAP access point name.
fingerprint Hexadecimal fingerprint of the MAP’s public encryption key.
This field is displayed only for Distributed MAPs. If the field is
blank, the key has not been verified yet by an administrator.
boot-download-
enable
State of the firmware upgrade option:
 YES (automatic upgrades are enabled)
 NO (automatic upgrades are disabled)
load balancing group Names of the MAP load-balancing groups to which the MAP
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of a
group.
Radio Radio number. The information listed below this field applies
specifically to the radio.
type Radio type:
 802.11a
 802.11b
 802.11g