Command Reference Guide

display {ap | dap} config 277
display {ap | dap}
config
Displays global and radio-specific settings for an MAP access point.
Syntax —
display ap config [port-list [radio {1 | 2}]]
Syntax — display dap config [dap-num [radio {1 | 2}]]
 port-list — List of ports connected to the MAP access point(s) for
which to display configuration settings.
 dap-num — Number of a Distributed MAP for which to display
configuration settings.
 radio 1 — Shows configuration information for radio 1.
 radio 2 — Shows configuration information for radio 2. (This option
does not apply to single-radio models.)
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Usage — MSS lists information separately for each MAP access point.
Examples — The following example shows configuration information for
an MAP access point on WX port 2:
WX1200# display ap config 2
Port 1: AP model: AP2750, POE: enable, bias: high, name: MAP01
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: dynamic, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
The following example shows configuration information for a Distributed
MAP access point configured on connection 1:
WX4400# display dap config 1
Dap 1: Serial-Id: M9DE48B012F00, MAP model: AP2750, bias: high, name: DAP1
boot-download-enable: YES
Radio 1: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Table 52 describes the fields in this display.