Command Reference Guide

276 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
success: change accepted.
WX4400# clear service-profile svcprof6
success: change accepted.
See Also
 clear radio-profile on page 274
 set radio-profile mode on page 342
clear service-profile Removes a service profile or resets one of the profile’s parameters to its
default value.
Syntax —
clear service-profile name
 name — Service profile name.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 3.0.
Usage — If the service profile is mapped to a radio profile, you must
remove it from the radio profile first. (After disabling all radios that use
the radio profile, use the clear radio-profile name service-profile name
command.)
Examples — The following commands disable the radios that are using
radio profile rp6, remove service-profile svcprof6 from rp6, then clear
svcprof6 from the configuration.
WX1200# set radio-profile rp6 mode disable
WX1200# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
WX1200# clear service-profile svcprof6
success: change accepted.
See Also
 clear radio-profile on page 274
 set radio-profile mode on page 342