Command Reference Guide

9
MANAGED ACCESS POINT
COMMANDS
Use MAP access point commands to configure and manage MAP access
points. Be sure to do the following before using the commands:
 Define the country-specific IEEE 802.11 regulations on the WX switch.
(See set system countrycode on page 54.)
 Install the MAP access point and connect it to a port on the WX
switch.
 Configure a MAP access port (for a directly connected MAP) or a
Distributed MAP. (See set port type ap on page 87 and set dap on
page 77.)
CAUTION: Changing the system country code after MAP configuration
disables MAP access points and deletes their configuration. If you change
the country code on a WX switch, you must reconfigure all MAP access
points.
MAP Access Point
Commands by
Usage
This chapter presents MAP access point commands alphabetically. Use
Table 50 to locate commands in this chapter based on their use.
Table 50 Map Access Point Commands by Usage
Type Command
Automatic
Configuration of
Distributed MAPs
set dap auto on page 306
set dap auto mode on page 308
set {ap | dap} bias on page 310
set {ap | dap} blink on page 311
set {ap | dap} group on page 313