Command Reference Guide

196 CHAPTER 6: IP SERVICES COMMANDS
3 red Up Up 5
10 backbone Up Up 5
1 none Up
2 none Up
When the administrator presses Ctrl+t to end the Telnet connection, the
management session returns to the local prompt:
WX1200-remote> Session 0 pty tty2.d terminated tt name tty2.d
WX1200#
See Also
 clear sessions on page 497
 display sessions on page 500
traceroute Traces the route to an IP host.
Syntax —
traceroute host [dnf] [no-dns] [port port-num]
[queries num] [size size] [ttl hops] [wait ms]
 host — IP address, hostname, or alias of the destination host. Specify
the IP address in dotted decimal notation.
 dnf — Sets the Do Not Fragment bit in the ping packet to prevent the
packet from being fragmented.
 no-dns — Prevents MSS from performing a DNS lookup for each hop
to the destination host.
 port port-num — TCP port number listening for the traceroute
probes.
 queries num — Number of probes per hop.
 size size — Probe packet size in bytes. You can specify from 40
through 1,460.
 ttl hops — Maximum number of hops, which can be from 1 through
255.
 wait ms — Probe wait in milliseconds. You can specify from 1 through
100,000.
Defaults
 dnf — Disabled