Command Reference Guide

192 CHAPTER 6: IP SERVICES COMMANDS
See Also
 set snmp community on page 160
 set snmp notify target on page 162
 set snmp profile on page 167
 set snmp protocol on page 172
 set snmp security on page 173
 set snmp usm on page 174
 display snmp community on page 186
 display snmp counters on page 187
 display snmp notify profile on page 188
SNMP minimum security Lowest (least secure) security level set on the switch:
 authenticated—SNMP message exchanges are
authenticated but are not encrypted.
 auth-req-unsec-notify—SNMP message exchanges
are authenticated but are not encrypted, and
notifications are neither authenticated nor
encrypted.
 encrypted—SNMP message exchanges are
authenticated and encrypted.
 unsecured—SNMP message exchanges are not
secure.
System Name String configured by the set system name command.
System location String configured by the set system location
command.
System contact String configured by the set system contact
command.
SNMP engine ID Unique ID of this SNMP engine.
SNMP engine boots Number of times the SNMP engine has booted. This
number is at least as great as the number of times the
switch has booted.
SNMP engine time Number of seconds since the SNMP engine was
rebooted.
SNMP max message size Maximum length, in bytes, of SNMP messages sent by
this SNMP engine.
Table 41 Output for display SNMP status (continued)
Field Description