Command Reference Guide

display snmp status 191
display snmp status Displays SNMP version and status information.
Syntax —
display snmp status
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Examples — To display SNMP version and status information, use the
following command:
WX-1200# display snmp status
Server:
SNMP agent (server) is enabled
SNMPv1 is enabled
SNMPv2c is disabled
SNMPv3/USM is disabled
SNMP minimum security is unsecured
System name: pubs
System location: -- not set --
System contact: -- not set --
SNMP engine ID: 00000063000000a1c0a80142 (IP
192.168.1.66:161)
SNMP engine boots: 1
SNMP engine time: 19410
SNMP max message size: 2048
Table 41 describes the fields in this display.
Table 41 Output for display SNMP status
Field Description
SNMP agent (server) is State of the SNMP service on the switch:
 Enabled
 Disabled
SNMPv1 is ...
SNMPv2c is ...
SNMPv3 is ...
State of each supported protocol version of SNMP:
 Enabled
 Disabled