Command Reference Guide
178 CHAPTER 6: IP SERVICES COMMANDS
min — Minute to start or end the time change — a value between 0
and 59.
end — End of the time change period.
Defaults — If you do not specify a start and end time, the system
implements the time change starting at 2:00 a.m. on the first Sunday in
April and ending at 2:00 a.m. on the last Sunday in October, according to
the North American standard.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must first set the time zone with the set timezone
command for the offset to work properly without the start and end
values.
Configure summertime before you set the time and date. Otherwise,
summertime’s adjustment of the time will make the time incorrect, if the
date is within the summertime period.
Examples — To enable summertime and set the summertime time zone
to PDT (Pacific Daylight Time), type the following command:
WX1200# set summertime PDT
success: change accepted
See Also
clear snmp usm on page 122
clear timezone on page 124
display summertime on page 138
display timedate on page 138
display timezone on page 139
set timedate on page 180
set timezone on page 181