Command Reference Guide

set snmp usm 175
 ip ip-addr — ID is based on the IP address of the station running
the management application. Enter the IP address of the station.
MSS calculates the engine ID based on the address.
 local — Uses the value computed from the switch’s system IP
address.
 access {read-only | read-notify | notify-only | read-write
| notify-read-write}
Specifies the access level of the user:
 read-only — An SNMP management application using the string
can get (read) object values on the switch but cannot set (write)
them.
 read-notify — An SNMP management application using the
string can get object values on the switch but cannot set them. The
switch can use the string to send notifications.
 notify-only — The switch can use the string to send
notifications.
 read-write — An SNMP management application using the string
can get and set object values on the switch.
 notify-read-write — An SNMP management application using
the string can get and set object values on the switch. The switch
can use the string to send notifications.
 auth-type {none | md5 | sha} {auth-pass-phrase string |
auth-key hex-string}
Specifies the authentication type used to authenticate
communications with the remote SNMP engine. You can specify one
of the following:
 none—No authentication is used.
 md5—Message-digest algorithm 5 is used.
 sha—Secure Hashing Algorithm (SHA) is used.
If the authentication type is
md5 or sha, you can specify a passphrase
or a hexadecimal key.