Command Reference Guide

set interface dhcp-server 145
Examples — The following command enables the DHCP client on VLAN
corpvlan:
WX-1200# set interface corpvlan ip dhcp-client enable
success: change accepted.
See Also
 clear interface on page 115
 display dhcp-client on page 182
 display interface on page 126
set interface
dhcp-server
Configures the MSS DHCP server.
Use of the MSS DHCP server to allocate client addresses is intended for
temporary, demonstration deployments and not for production
networks. 3Com recommends that you do not use the MSS DHCP server
to allocate client addresses in a production network.
Syntax — set interface vlan-id ip dhcp-server [enable | disable]
[start ip-addr1 stop ip-addr2]
 vlan-id — VLAN name or number.
 enable — Enables the DHCP server.
 disable — Disables the DHCP server.
 start ip-addr1 — Specifies the beginning address of the address range
(also called the address pool).
 stop ip-addr2 — Specifies the ending address of the address range.
Defaults — The DHCP server is enabled by default on a new
(unconfigured) WXR100 or WX1200, in order to provide an IP address to
the host connected to the switch for access to the Web Quick Start. On
all switch models, the DHCP server is enabled and cannot be disabled for
directly connected MAPs.
The DHCP server is disabled by default for any other use.
Access — Enabled.
History —Introduced in MSS Version 4.0.