Command Reference Guide

122 CHAPTER 6: IP SERVICES COMMANDS
See Also
 set snmp notify target on page 162
 display snmp notify target on page 189
clear snmp profile Clears an SNMP notification profile.
Syntax — clear snmp profile profile-name
 profile-name — Name of the notification profile you are clearing.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Examples — The following command clears notification profile
snmpprof_rfdetect:
WX-1200# clear snmp profile snmpprof_rfdetect
success: change accepted.
See Also
 set snmp profile on page 167
 display snmp notify profile on page 188
clear snmp trap
receiver
This command is deprecated in MSS Version 4.0. To clear an SNMP
notification target (also called trap receiver), see clear snmp notify
target on page 121.
clear snmp usm Clears an SNMPv3 user.
Syntax — clear snmp usm usm-username
 usm-username — Name of the SNMPv3 user you want to clear.
Defaults — None.