CLI Reference Guide

Locating and Fixing Coverage Holes 461
 Install new MAPs and add them to the network plan. Using this
method, you install the new MAP first, then integrate it into your
network plan.
Computing and
Placing New MAPs
The procedure for computing and placing new MAPs is the same as the
procedure you use for initial planning. Make sure you lock the existing
MAPs in place before you compute and place the new MAPs. (See
“Computing MAP Placement” on page 152.)
Adding New MAPs
that Are Already
Installed to the
Network Plan
If you installed a new MAP in the network and you want to add it to the
network plan, do the following:
1 Use the Network Verification tab to upload the MAP configuration into
3WXM. (See “Verifying Configuration Information” on page 327.)
2 In the Organizer panel, right-click on the floor and select Properties. The
Floor wizard appears.
3 Click Plan RF Coverage at the top of the wizard. The Plan RF Coverage
page appears.
4 In the Coverage Areas section, right-click on the coverage area for which
the MAP is providing coverage, and select Edit Properties. The Modify
Coverage Area wizard appears.
5 Click Area Associations at the top of the wizard.
6 Click Choose Available next to the Access Point List group box, and
select the MAP.
7 Click Finish to save the changes and close the wizard.
8 Click on Objects to Place.
9 Click on the MAP icon, then click on the location where you installed the
MAP. The MAP icon moves from the Objects To Place tab to its location
on the floor.