CLI Reference Guide

458 CHAPTER 13: OPTIMIZING A NETWORK PLAN
 If the number is greater than 0, 3WXM successfully imported
measurements.
 If the number is 0, no measurements were imported. Try the import
again. If you are using a site survey file, verify that the map name is
correct.
Applying the RF
Measurements to the
Floor Plan
1 On the Optimize RF Coverage page of the Building wizard, click
Optimize.
A wizard appears, listing the progress of the request.
 The Total number of RF measurements that did not intersect any
object line lists the number of measurements that did not experience
attenuation due to an RF obstacle in the path between them.
If the measurements came from a site survey file, they are
measurements between the portable AP (LOS point) and the PC
running the site survey tool. If the measurements came from MAP
radios in the network, they are measurements between MAP radios.
 The Total number of objects that will be corrected line indicates the
number of measurements that did experience attenuation. For
existing RF objects, 3WXM corrects the attenuation to match the
results. If the floor plan does not have an RF obstacle where the
attenuation library indicates one exists, 3WXM creates an RF obstacle.
For RF obstacles created by 3WXM, the description is
auto-generated and the obstacle type is Other. You can edit these
values by selecting the obstacle, clicking the Edit properties icon to
open the Modify RF Obstacle wizard, and modifying the values. Click
Finish to close the wizard and save the changes. (See “To use the
Create RF Obstacle Dialog box” on page 132. The wizard is the same
whether it is labeled Create or Modify.)
2 Click Finish.