CLI Reference Guide

452 CHAPTER 12: GENERATING REPORTS
Generating a Site
Survey Order
The site survey order contains the locations and MAC addresses of the
line-of-site (LOS) points for use when conducting a site survey, and also
provides a GIF image of the floor.
For the site survey order to be meaningful, you must specify the
line-of-site (LOS) points first. (See “Placing RF Measurement Points” on
page 169.)
To generate a site survey order
1 Select Reports > Site Survey Order from the toolbar in the main 3WXM
window.
The Site Survey Order Generation dialog box appears.
2 Select the scope for the work order. You can select the network plan, a
site, a building, or an individual floor.
3 Select the language:
 English
 German
4 To change the output directory for the report, click on the button next to
output directory, navigate to the new directory, and click Select.
5 Click Generate.
6 When the report is generated, click View. A browser window containing
the report opens.
7 Optionally, select the floor.
8 Click View Site Survey Order. The site survey order appears. LOS point
information for the selected floor is displayed.
Scroll down to view the MAC address assignments for the LOS points.
Use the instructions in the Ekahau Site Survey Initial Setup section of the
work order to set up the survey.
When you import the floor map into the site survey tool, make sure you
use the map name specified in the work order. The site survey data will
not appear when you import RF measurements into 3WXM unless the
map name is correct.