CLI Reference Guide

Synchronizing Local and Network Changes 337
To undo changes
1 Select one or more WX switches.
To select multiple WX switches, press Shift (for contiguous WX switches)
or Control (for noncontiguous WX switches) while clicking.
2 Do one of the following:
 To undo local changes, click Undo in the Local Changes group box.
 To undo network changes, click Undo in the Network Changes group
box.
The status is shown in the Network Status and Local Status columns.
Synchronizing When
the Network and
3WXM Have
Nonmatching
Changes
If a WX switch in the network has configuration changes, and the
switch’s counterpart in the network plan also has changes but the
changes are different, you still can synchronize the changes.
The Managed Devices tab indicates that both the network and the
network plan have nonmatching changes in the following ways:
 When you select the WX switch, the buttons in both the Local
Changes and Network Changes group boxes become active.
 If you click Deploy, the deploy is not performed and the following
message is displayed instead: wx is not synchronized.
To synchronize the changes, do one of the following:
 Review and either deploy (local changes) or accept (network changes)
the changes, then review and either deploy or accept the other set of
changes.
 Reject one set of changes (local or network) and accept or deploy the
other set of changes.
 Reject both sets of changes.
Modifying
Configuration
Change Polling
Options
By default, 3WXM client polls WX switches in the network every 15
minutes for network changes, and displays a popup message if changes
are detected. The popup message is in addition to notification in the
Alerts panel.