CLI Reference Guide

Verifying Configuration Information 329
Filtering the Message
List
By default, all warning and error messages are listed. You can use the
following options to filter the message list:
 Show Errors — Error messages are listed only when this option is
selected.
 Show Warnings — Warning messages are listed only when this
option is selected.
 Show Disabled — Disabled rules are listed only when this option is
selected. (See “Disabling a Rule from the Message List” on page 330.)
Resolving an Error or
Warning
For most errors and warnings, 3WXM provides a link to edit the
configuration information that caused the error or warning. The link
appears in the Resolutions section of the tab, under the Messages
column. When you click the edit link, 3WXM opens the configuration
wizard for the configuration item.
For example, if you create a new WX switch called dang-WXR100 but
you do not specify the system IP address of the WX switch, the error
message System IP is not assigned or is not valid appears in the Message
area. To correct the error, click on Edit dang-WXR100 in the Resolutions
section. The Modify WX switch wizard appears. Use the wizard to edit
the System IP address. After you save the configuration change, 3WXM
reevaluates the WX switch’s configuration. If the system IP address is
specified, the error no longer appears in the Verification tab.
To resolve an error or warning
1 Select the error or warning message in the Message column.
2 Read the information in the Error/Warning Details section. For some
errors and warnings, this section contains information about how to
resolve the error or warning.
3 If an Edit option is listed in the Resolution section, click on the option to
display the configuration wizard for the item.
4 Edit the configuration item or resolve the network issue and save the
change.
5 In the Verification tab, click Refresh on the tab’s toolbar.
6 Check the messages to see whether the error or warning is gone.