CLI Reference Guide

308 CHAPTER 7: CONFIGURING AUTHENTICATION, AUTHORIZATION, AND ACCOUNTING PARAMETERS
Setting Up ACL Basic Properties
To set up ACL basic properties:
1 Access the WX Switch wizard for the WX switch. (See “Accessing the WX
Switch Wizard” on page 187.)
2 Select AAA at the top of the wizard, if not already selected.
3 Select Mobility Profile from the organizer list on the left side of the page,
if not already selected.
4 Click New ACL. The Create ACL wizard appears.
5 In the ACL Name box, type the name for the ACL (1 to 32 alphanumeric
characters, with no spaces or tabs). The name can include hyphens (-),
underscores (_), or periods (.). ACL names are case-sensitive and must
begin with a letter. Do not include any of the following terms in the
name: all, default-action, map, help, editbuffer.
6 Go to “Defining Access Control Entries”.
Defining Access Control Entries
As part of defining ACL properties, you need to define access control
entries (ACEs) for the ACL. You can add the following types of ACEs to
an ACL:
 IP — Filters packets by source and destination IP addresses, type of
service (TOS), or precedence. For more information, see “Creating an
IP ACE” on page 309.
 TCP — Filters packets by established TCP connections, source and
destination IP addresses, TOS, precedence, or TCP source and
destination ports. For more information, see “Creating a TCP or UDP
ACE” on page 311.
 ICMP — Filters packets by source and destination IP addresses, TOS,
precedence, ICMP type, or ICMP code. For more information, see
“Creating an ICMP ACE” on page 312.
 UDP — Filters packets by source and destination IP addresses, TOS,
precedence, or UDP source and destination ports. For more
information, see “Creating a TCP or UDP ACE” on page 311.
 Layer 4 Protocol — Filters packets by source and destination IP
addresses, TOS, precedence, or Layer 4 protocol. For more
information, see “Creating a Layer 4 Protocol ACE” on page 314.