CLI Reference Guide

284 CHAPTER 7: CONFIGURING AUTHENTICATION, AUTHORIZATION, AND ACCOUNTING PARAMETERS
You can add one or both methods to the list.
 If you specify a RADIUS server group as the first method and a user is
denied access by the RADIUS server, no authentication and
authorization are attempted with the other methods specified in the
list.
 If you specify LOCAL as the first method and a user is not in the local
user database on the WX, authentication and authorization are
attempted with a RADIUS server group if one is defined in the method
list.
The method you select for authentication is also used for authorization.
To add a server group, click Create and go to “To define a RADIUS server
group” on page 268. After you create the server group, click Choose
Available and then select the server group from the list.
4 Do one of the following:
 To configure accounting, go to “To set the accounting method for
administrator access”.
 To save changes and close the wizard, click Finish.
To set the accounting method for administrator access
1 Click Accounting at the top of the wizard.
2 To enable this accounting rule, select Enabled. By default, a rule you
configure in 3WXM is disabled, which means 3WXM does not add the
rule to a WX switch’s configuration.
3 Select one of the following record options:
 Select Start-Stop to specify that records are sent at the start of a
session and the end of a session.
 Select Stop-Only to specify that records are sent only at the end of a
session.
4 To select the accounting method, click Choose Available, then select
the method from the list:
 RADIUS server group — A server group that you have configured
previously.
 LOCAL — The WX switch’s local database.
You can add one or both methods to the list.