CLI Reference Guide

Installing 3WXM 27
Installing the HP
OpenView Plug-In
To install the HP OpenView plug-in:
1 Complete step 9 of the procedure in “Using the Installation Wizard” on
page 24.
2 Click Next. The Select Plug-in page appears.
3 Select the HPOV checkbox and click Next.
The License Agreement page appears. After reading the 3WXM license
agreement, select whether to accept the terms of the agreement. (If you
choose not to accept the terms of the license agreement, you cannot
proceed with the installation.)
4 Click Next.
5 To specify the directory in which HP OpenView Network Node Manager is
installed, click Choose.
Network Node Manager must be already be installed on the system. You
must specify the correct directory for Network Node Manager for the HP
OpenView plug-in to be installed correctly. The default Network Node
Manager installation directory is C:\Program Files\HP OpenView\NNM.
Click Restore Default Folder to reset the directory to the default value.
6 Click Next to display the Pre-Installation Summary page.
7 Check the installation summary information. Click Previous to make any
changes to previous pages.
8 Click Install.
When installation is complete, a page is displayed to report that the
installation was successful. The page also identifies the directory in which
3WXM was installed.
9 Click Done.
See “Getting Started” on page 75 for more information on getting
started with 3WXM. For more information about using HP OpenView
with 3Com products, see “Using 3WXM With HP OpenView” on
page 463.