CLI Reference Guide

Configuring Directly Connected MAP Access Points 257
To modify a MAP
connection
You can change connection parameters for a MAP, including the WX
port (for directly connected MAPs).
For MAP models that have two Ethernet ports, you also can add or
change the second WX connection for redundancy.
1 On the MAP page of the Wireless page of the WX Switch wizard, select a
MAP port, then click Modify MAP. The Modify MAP wizard appears.
2 Select the connection you want to change and click Modify. The Modify
Direct Connection or Modify Distributed Connection dialog box appears,
depending on the connection type.
3 Modify connection parameters:
a To change the WX switch for the connection, select the WX switch
from the WX pull-down list.
b To change the MAP port number or Distributed MAP connection
number, select the new value from the Port or DAP Number
pull-down list.
c To change the connection bias, select the new value from the Bias
pull-down list.
d To add the MAP to a MAP group for session load balancing, type the
group name in the Load Balance Group box.
4 Click Finish to close the dialog.
5 Click Finish again to save the changes and close the Modify MAP or
Modify Distributed MAP wizard.