CLI Reference Guide

254 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
Select No to disable automatic firmware upgrading. Automatic firmware
upgrading is enabled by default.
10 Do one of the following:
 To modify radio settings for the MAP, see “To modify radio settings”.
 To modify connection settings for the MAP, see “To modify a MAP
connection” on page 257.
 To save changes and close the wizard, click Finish.
To modify radio
settings
To modify radio settings, use the following procedure.
1 On the MAP page of the Wireless page of the WX Switch wizard, select a
MAP port, then click Modify MAP. The Modify MAP wizard appears.
2 Click Next. A radio page appears.
3 To enable the radio, select Enabled.
4 If the MAP model supports external antennas, select the external antenna
model from the Antenna Type box.
 An MP-nnn 802.11b/g radio can use one of the following antenna models:
 Internal
 ANT1060
 ANT1120
 ANT1180
 An MP-nnn 802.11a radio can use one of the following antenna models:
 Internal
 ANT5060
 ANT5120
 ANT5180
 An APnnnn radio can use one of the following dual-band antenna models:
 Internal
 ANT3C591
 ANT3C592
 ANT3C597
 ANT3C598