CLI Reference Guide

252 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
You can see that the port has been labeled as a MAP port and has PoE
enabled. Enable all ports as MAP ports by selecting MAP Enabled in the
MAP Enabled column heading.
5 Click in the Name column for a MAP port you enabled, and type a name
for it (1 to 16 alphanumeric characters, with no spaces or tabs).
6 To select the MAP type, click on the MAP Type cell for the port, and select
the MAP type from the list.
7 To select the radio type for a single-radio model, click the MAP Radio
Type box and select the radio type from the list:
 11a — 802.11a
 11b — 802.11b only
 11g — 802.11b/g
8 To disable PoE, clear the PoE checkbox for the port.
9 Do one of the following:
 To modify MAP settings, click Modify MAP and see “To modify MAP
attributes”.
 Click Finish to save the changes and close the wizard.
To m od i f y MA P
attributes
To modify MAP attributes, use the following procedure.
1 On the MAP page of the Wireless page of the WX Switch wizard, select a
MAP port, then click Modify MAP. The Modify MAP wizard appears.
2 Select the MAP model from the MAP Model list.
3 To select the radio type for a single-radio model, click the MAP Radio
Type box and select the radio type from the list:
 11a — 802.11a
 11b — 802.11b only
 11g — 802.11b/g
4 In the Name box, type a name (1 to 16 alphanumeric characters, with no
spaces or tabs).
5 In the Serial Number box, type the serial ID of the MAP.