CLI Reference Guide

250 CHAPTER 6: CONFIGURING WIRELESS PARAMETERS
To map the radio
profile to a service
profile
To map the radio profile to a service profile, use the following procedure.
1 In the Create Radio Profile wizard, click Service Profile Selection. The
Service Profile Selection page appears.
2 Select the service profile in the Available Service Profiles list.
3 Click Add to move the profile name to the Current Service Profiles
column.
4 Do one of the following:
 To apply the radio profile to 3Com radios, click Next and see “To
apply a radio profile to radios”.
 To configure other radio profile parameters, click a button at the top
of the wizard.
 To close the wizard and save the changes, click Finish.
To apply a radio profile to radios
1 In the Create Radio Profile wizard, click Radio Selection. The Radio
Selection page appears.
If the Available Members column is empty, no MAP access points have
been configured for the WX switch yet. To configure MAP access points,
see “Configuring Directly Connected MAP Access Points” on page 251
and “Configuring Distributed MAP Access Points” on page 258. After you
configure the MAP access points, return to this wizard page to apply the
radio profile to radios.
2 Select the radios from the Available Members column.
3 Click Add to move the radios to the Current Members column.
4 Click Finish to save the changes and close the wizard.