CLI Reference Guide

232 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
Setting NTP Properties
To set NTP properties:
1 Do one of the following:
 Open the WX Switch wizard, then select NTP under IP Services in the
organizer list of the System and Administrative page.
 In the Organizer panel, select IP Services under a WX switch, then
select Config > Edit. The Modify IP Services wizard appears. Click on
NTP at the top of the wizard.
2 To enable NTP, select Enabled. To disable NTP, clear Enabled. By
default, NTP is disabled.
3 If you disabled NTP in step 2, go to step 5. Otherwise, go to the next
step.
4 To set the interval at which an NTP server is polled, specify its value in
seconds (16 to 1024) in the Update Interval box. The default is 64
seconds.
5 Do one of the following:
 Go to “Configuring ARP”.
 Select another item in the WX Switch wizard, if you are using this
wizard.
 Click Finish to close the wizard and save changes.
Creating NTP Servers
To create an NTP server:
1 Do one of the following:
 Open the WX Switch wizard, then select NTP under IP Services in the
organizer list of the System and Administrative page.
 In the Organizer panel, select IP Services under a WX switch, then
select Config > Edit. The Modify IP Services wizard appears. Click on
NTP at the top of the wizard.
2 Click on a row in the NTP Server IP Address column.
3 Click New NTP Server.
4 Edit the IP address.
5 To add more NTP servers, repeat for every server. You can add a total of
three NTP servers.