CLI Reference Guide

226 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
5 To add a port to the port group, select the Member checkbox for the
port. The port group name appears in the Port Group column for the
port.
6 To remove a port from a port group, clear the Member checkbox for the
port.
7 To change the membership of a port that is in another port group, select
the Member checkbox for the port.
The Port Group Member Remove dialog box appears. Click Yes to
change the port’s membership. Click No to leave the membership
unchanged.
8 Click Finish to save the changes.
9 Do one of the following:
 Go to “Configuring IP Services”.
 Select another item in the WX Switch wizard, if you are using this
wizard.
 Click Finish to close the wizard and save changes.
Configuring IP
Services
You can configure the following IP services:
 Static routes (See “Configuring Static Routes” on page 226.)
 IP aliases (See “Configuring IP Aliases” on page 229.)
 Domain Name System (DNS) service (See “Configuring DNS” on
page 230.)
 Network Time Protocol (NTP) service (See “Configuring NTP” on
page 231.)
 Address Resolution Protocol (ARP) entries (See “Configuring ARP” on
page 233.)
Configuring Static
Routes
The IP routing table contains routes that MSS uses for determining the
interfaces for a WX switch’s external communications. When you add an
IP interface to a VLAN that is up, MSS automatically adds corresponding
entries to the IP routing table.