CLI Reference Guide

214 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
 In the Organizer panel, select Management Services under a WX
switch, then select Notification Target under SNMP. Select Config >
Edit.
2 Specify the target ID.
3 Type the IP address of the target.
4 Specify the protocol port on which the target listens for SNMP
notifications. The default is 162.
5 Select the notification profile that will use this target.
6 From the Security Model pull-down list, select the SNMP version.
7 For SNMPv3, select the security level:
 Unsecured—SNMP message exchanges are not secure. This is the
default, and is the only value supported for SNMPv1 and SNMPv2c.
(This security level is the same as the noAuthNoPriv level described in
SNMPv3 RFCs.)
 Authenticated—SNMP message exchanges are authenticated but
are not encrypted. (This security level is the same as the authNoPriv
level described in SNMPv3 RFCs.)
 Encrypted—SNMP message exchanges are authenticated and
encrypted. (This security level is the same as the authPriv level
described in SNMPv3 RFCs.)
8 For SNMPv1 or SNMPv2c, select the SNMP community string.
9 For SNMPv2c or SNMPv3, select the notification type:
 Inform—The switch expects to receive acknowledgements from the
notification target.
 Trap—The switch does not expect to receive acknowledgements from
the notification target.
10 To change the acknowledgement settings for informs, specify the
following:
a In the Timeout box, specify the number of seconds you want the
switch to wait for acknowledgement of a notification. You can specify
from 1 to 5 seconds. The default is 2.
b In the Retry Count box, specify the number of times the MSS SNMP
engine will resend a notification that has not been acknowledged by
the target. You can specify from 0 to 3 retries. The default is 0.
11 For SNMPv3, select the USM user.