CLI Reference Guide

Configuring WX Management Services 209
On each switch in the network plan, you must enable notifications and
configure 3WXM Services as a notification target (trap receiver).
3WXM Services does not start listening for SNMP notifications from
switches until you save the network plan.
To configure SNMP:
1 Do one of the following:
 Open the WX Switch wizard, then select SNMP under Management
Services in the organizer list of the System and Administrative page.
 In the Organizer panel, select Management Services under a WX
switch, then select Config > Edit. Click on SNMP at the top of the
wizard.
2 Select Enabled to enable SNMP service on the WX, or clear Enabled to
disable SNMP service. By default, SNMP is disabled.
3 To change the minimum level of security MSS requires for SNMP, select
one of the following from the Security Level pull-down list:
 Unsecured—SNMP message exchanges are not secure. This is the
default, and is the only value supported for SNMPv1 and SNMPv2c.
(This security level is the same as the noAuthNoPriv level described in
SNMPv3 RFCs.)
 Authenticated—SNMP message exchanges are authenticated but
are not encrypted. (This security level is the same as the authNoPriv
level described in SNMPv3 RFCs.)
 Encrypted—SNMP message exchanges are authenticated and
encrypted. (This security level is the same as the authPriv level
described in SNMPv3 RFCs.)
 AuthRequest-UnsecuredNotify—SNMP message exchanges are
authenticated but are not encrypted, and notifications are neither
authenticated nor encrypted.
The only security level supported for SNMPv1 and SNMPv2c is Unsecured.
4 Select the version(s) of SNMP you want the switch to run:
 V1
 V2c
 USM (SNMPv3)
5 See the following sections for more configuration options.