CLI Reference Guide

208 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
3 Do one of the following:
 Go to “Disabling or Reenabling WebAAA”.
 Select another item in the WX Switch wizard, if you are using this
wizard.
 Click Finish to close the wizard and save changes.
Disabling or
Reenabling WebAAA
To disable or reenable WebAAA on the WX:
1 Do one of the following:
 Open the WX Switch wizard, then select HTTPS, Telnet, SSH & Web
Portal under Management Services in the organizer list of the System
and Administrative page.
 In the Organizer panel, select Management Services under a WX
switch, then select Config > Edit. Click on HTTPS, Telnet, SSH &
Web Portal at the top of the wizard.
2 Select Enabled to enable WebAAA access, or clear Enabled to disable
WebAAA access. By default, WebAAA access is enabled.
3 Do one of the following:
 Go to “Configuring SNMP”.
 Select another item in the WX Switch wizard, if you are using this
wizard.
 Click Finish to close the wizard and save changes.
Configuring SNMP You can monitor your network by using the Simple Network
Management Protocol (SNMP). SNMP is a protocol used to exchange
information about network activity between network devices. By default,
SNMP is disabled.
You can configure the following SNMP parameters:
 Enable or disable SNMP service on the WX.
 Enable or disable individual SNMP versions.
 Configure notification profiles to enable SNMP notifications.
 Specify community strings and USM (SNMPv3) users.
 Specify SNMP notification targets (trap receivers).