CLI Reference Guide

Configuring WX Management Services 207

Configuring Telnet To configure Telnet access to the WX:

1 Do one of the following:

 Open the WX Switch wizard, then select HTTPS, Telnet, SSH & Web

Portal under Management Services in the organizer list of the System

and Administrative page.

 In the Organizer panel, select Management Services under a WX

switch, then select Config > Edit. Click on HTTPS, Telnet, SSH &

Web Portal at the top of the wizard.

2 Select Enabled to enable Telnet access, or clear Enabled to disable

Telnet access. By default, Telnet access is disabled.

3 In the Service Port Number box, type the TCP port number for the Telnet

server on the WX switch. The default TCP port is 23.

4 Do one of the following:

 Go to “Configuring SSH”.

 Select another item in the WX Switch wizard, if you are using this

wizard.

 Click Finish to close the wizard and save changes.

Configuring SSH This section explains how to configure SSH access to the WX.

Before using SSH, you must use the CLI to generate an SSH

authentication key on each WX switch you want to manage using SSH.

You cannot generate the key with 3WXM. For information, see the

Wireless LAN Switch and Controller Configuration Guide.

To configure SSH access to the WX: