CLI Reference Guide

194 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
10 In the Aging Time box, specify the aging timeout period (0 to 1,000,000
seconds) for dynamic entries in the forwarding database. The default is
300 seconds (5 minutes). If you specify 0, aging is disabled.
11 Do one of the following:
 To configure VLAN membership, click Next to display the VLAN
Member Selection page. (See “Adding Ports to a VLAN” on
page 194.)
 To close the wizard and save the changes, click Finish.
Adding Ports to a VLAN
You can add ports or port groups (if you have defined them) to a VLAN.
After adding a port or port group, you can also assign a tag value to the
port or port group. A tag is a numeric value that identifies a virtual port
within the VLAN. The same VLAN can have different tag values on
different ports. However, a port can have only one tag value in a given
VLAN. A VLAN can also have untagged ports. An untagged port can be a
member of only one VLAN.
MSS supports the IEEE 802.1Q tag type, described in the IEEE 802.1Q
specification.
To configure VLAN membership:
1 In the Modify VLAN wizard, click VLAN Member Selection. The VLAN
Member Selection page appears.
Only ports configured as network ports are listed. You cannot add MAP
access ports, Distributed MAPs, or wired authentication ports to a VLAN.
2 From the list of available members, select a port or port group (if you
previously created port groups).
If a port or port group is currently a member of a VLAN, the VLAN name
is listed in the VLAN(s) column. To make multiple selections, press Shift
(for contiguous items) or Control (for noncontiguous items) while
clicking items.
3 Do one of the following:
 To add a port or port group to the VLAN and remove previous VLAN
membership, click Move.
Moving a port or port group could potentially affect multiple VLANs.