CLI Reference Guide

Defining Wireless Coverage Areas 151
12 Do one of the following:
 To close the wizard and save the changes, click Finish.
 To configure radio attributes, see “Configuring Radio Attributes” on
page 151.
Configuring Radio Attributes
To configure radio attributes:
1 In the Create Third-Party AP wizard, after placing a third-party access
point, click Next.
2 Verify the radio slot number and radio type.
For a dual-radio access point, 802.11b/g radios have a slot number of 1.
802.11a radios have a slot number of 2.
3 In the MAC Address box, type the MAC address of the radio.
4 To enable the radio, select Enabled.
The access point’s radio must be enabled in order to be considered in
channel allocation.
5 In the Transmit Power box, specify the transmit power for the radio.
6 In the Antenna Gain list, select the antenna gain for the radio.
7 In the Channel Number list, select the channel number for the radio.