CLI Reference Guide

Defining Wireless Coverage Areas 149
20 To change the number of redundant connections for the distributed
connection type, type the number in the Redundant Level box.
For direct connections, the redundancy level is always 1.
21 Click Finish to save the changes and close the wizard.
Adding a Third-Party
Access Point
If you have third-party access points in your network, you can draw them
on your floor layout. You can also configure the access point’s radio
attributes using 3WXM. These access points are taken into consideration
when 3WXM assigns channels to MAP access points.
You can use the Building wizard to include third-party access points. You
can also define third-party access points from the main 3WXM window
and place them on your floor layout by modifying the floor’s properties.
To configure 3WXM to acknowledge third-party APs when performing
rogue detection, see “Detecting and Combatting Rogue Devices” on
page 419
You also can add a third-party access point from the site wizard, when
creating or modifying a site. The wizard and its options are the same in
either case.
Setting Attributes for a Third-Party Access Point
1 In Miscellaneous group box on the Plan RF Coverage page, click the
Third-Party Access Point icon.
2 On the floor background image, click where you want the third-party
access point to be placed. The Create Third-Party AP wizard appears.