CLI Reference Guide

136 CHAPTER 4: PLANNING THE 3COM MOBILITY SYSTEM
Each floor plan must have at least one wiring closet, if the floor will use
MAPs that are directly connected to their WX switches. However, a floor
is not required to have a wiring closet if MAPs will be indirectly attached
through the network. In this case, if you do not create a wiring closet,
3WXM assumes the WX switch that will manage the Distributed MAPs
will be located in a wiring closet on another floor in the building.
To create a wiring closet
1 On the Plan RF Coverage page of the Building wizard, click the Wiring
Closet icon.
2 On the floor layout, click the location of the wiring closet. The Create
Wiring Closet dialog box appears.
3 In the Name box, type the name of the wiring closet (1 to 60 characters,
with no tabs).
4 If you have not defined a WX switch in 3WXM, click Finish to save the
changes. Otherwise, go to step 5.