CLI Reference Guide

128 CHAPTER 4: PLANNING THE 3COM MOBILITY SYSTEM
Drawing Floor
Objects Manually
You can use the Free Draw palette to add objects to your floor drawing
that are not related to RF obstacles (for example, a conference room table).
The tools for drawing non-RF objects work the same as the tools for
drawing RF objects, but the tools are different. To draw a non-RF object,
use the tools in the Free Draw group box. To draw RF objects, use the
tools in the Insert RF Obstacle group box. (See“Drawing RF Obstacles” on
page 133.)
To draw an object
1 In the Free Draw group box of the Edit Content page, click one of the
following icons and draw the object as described:
2 Click Finish to save the changes and close the wizard.
Object Action
(circle)
Diagonally drag the cursor over the area where you want
the circle to appear.
(square)
Diagonally drag the cursor over the area where you want
the square to appear.
(parallelogram)
1 Click at a vertex, and drag the cursor to the next vertex.
2 Click again, and drag the cursor until the parallelogram
takes the shape you want.
3 Click to finish.
(polygon)
1 Click at a vertex, then move the cursor to the next
vertex.
2 Repeat until the polygon takes the shape you want.
For a polygon with n sides, click n-1 additional times at
the vertices. For example, to draw a 7-sided polygon,
click at 6 vertices.
3 At the last vertex before completing the shape,
Right-click to complete the polygon.
(line)
1 Click at the start of the line.
2 Drag the cursor to the end of the line.
3 Click to finish.
(cursor)