CLI Reference Guide

Creating or Modifying Buildings in a Site 109
7 Do one of the following:
 Click Apply Changes to apply the numbering changes to the plan.
 Click Ignore Changes to clear the changes without applying them.
8 Do one of the following:
 Click the Floor Defaults tab to change the default values for unit of
measurement, ceiling height, and attenuation caused by ceilings. See
“Modifying Floor Defaults”.
 Click Next to configure floor information for the building. (See
“Importing or Drawing Floor Details”.)
 Click Finish to close the wizard and save the changes.
Modifying Floor
Defaults
3WXM applies the following values to each floor by default. The defaults
apply to all floors in the building plan.
 Unit of measurement is in feet.
 Ceiling height is 10 feet.
 Ceilings have attenuation of 10 dB for 802.11b/g and 802.11a.
1 In the Building wizard, click the Floor Defaults tab. The floor default
settings appear.
2 In the Unit of Measurement list, select Feet or Metric. If you are
importing a drawing of a floor plan, choose the measurement system the
drawing uses.
3 In the Height of the Ceiling box, type the number of feet or meters from
the floor to the ceiling (1 to 1000 feet or meters).