installation and reference guide HP MPIO Full Featured DSM for XP family of Disk Arrays 3.02.00 (AA-RVJ6H-TE, March 2009)

DescriptionMessageEvent
ID
A new path in excess of the supported number of paths
for an existing multipath disk has been discovered. X
represents the serial number of the disk. Y is the SCSI
address of the newly found path.
Too many paths for disk with
serial number X. Path (SCSI
address Y) not added.
303
A redundant path to an existing multipath disk has failed.
X represents the serial number of the disk. Y is the SCSI
address of the path that failed.
An unrecoverable path failure
occurred on SCSI address Y.
Disk X is still accessible
over redundant path(s).
304
The DSM was unable to successfully throttle I/O activity
within the time-out period, for the specified multipath
disk. X represents the serial number of the disk.
The DSM timed out on the I/O
throttle operation for
multipath capable disk X.
305
New LUN in excess of the supported number of LUNs
for an existing HBA to array port nexus has been
discovered. X represents the serial number of the disk.
Y is the SCSI address of the newly found path.
Number of LUNs exceeds the
maximum limit supported. Disk
X with path SCSI address Y
will be ignored.
306
The DSM cannot manage multipath capable disk X (SCSI
address Y) due to an internal error.
The DSM cannot manage mul-
tipath capable disk X (SCSI
address Y) due to an internal
error.
309
This event is logged when DSM detects that the path with
SCSI address Y is inconsistent and is moved to failed
state. X represents the serial number of the disk. A reboot
of the system is recommended to overcome this
inconsistent state.
The DSM detected an inconsist-
ency in the path (SCSI address
Y) to the multipath capable
disk X. This path has been
marked as failed.
310
Multipathing driver event log messages46