installation and reference guide HP MPIO Full Featured DSM for SAN Virtualization Services Platform 3.01.00 (5697-8031, March 2009)

DescriptionMessageEvent
ID
This event is logged when generation of removal event
notifications (Event IDs 304, 302 and 108) for the
multipath capable disk with serial number X has been
disabled upon request in the DSM.
The removal event notifica-
tions for multipath capable
disk X have been disabled
upon request.
111
This event is logged when generation of removal event
notifications (Event IDs 304, 302 and 108) for the
multipath capable disk with serial number X has been
enabled upon request in the DSM.
The removal event notifica-
tions for multipath capable
disk X have been enabled upon
request.
112
This event is logged when the last path to a multipath
capable disk with serial number X (for which the
generation of removal event notifications have been
disabled) is disconnected from the system.
The multipath capable disk X
has been disconnected from
the system.
113
This event is logged when a path to a multipath capable
disk with serial number X, is recovered from Unavailable
state. Y is the SCSI address of that path.
The path (SCSI address (Y))
for multipath capable disk X
has recovered from Unavail-
able state.
114
This event is logged when a path to a multipath capable
disk with serial number X, has become Unavailable. Y is
the SCSI address of that path.
The path (SCSI address (Y))
for multipath capable disk X
has become unavailable.
201
This event is logged when the volume failover
command issued over a path to a multipath capable disk
with serial number X, has failed. Y is the SCSI address of
that path.
The volume failover command
issued over the path (SCSI
address (Y)) for multipath
capable disk X has failed.
202
The DSM did not initialize successfully during startup.
The DSM failed to initialize
during startup.
301
All paths to an existing multipath disk have failed. X rep-
resents the serial number of the disk. Y is the SCSI address
of the last path that failed.
An unrecoverable path failure
occurred on SCSI address Y.
Disk X failed due to no re-
dundant paths available.
302
A new path in excess of the supported number of paths
for an existing multipath disk has been discovered. X
represents the serial number of the disk. Y is the SCSI
address of the newly found path.
Too many paths for disk with
serial number X. Path (SCSI
address Y) not added.
303
A redundant path to an existing multipath disk has failed.
X represents the serial number of the disk. Y is the SCSI
address of the path that failed.
An unrecoverable path failure
occurred on SCSI address Y.
Disk X is still accessible
over redundant path(s).
304
This event is logged when the DSM detects an unrecover-
able failure of a multipath capable disk, and requests
MPIO not to support this disk any further. Please check
the status of the multipath capable disk at the array end.
X represents the serial number of the disk.
An unrecoverable failure has
occurred on multipath capable
disk X. This disk will hence-
forth not be accessible.
307
Multipathing driver event log messages40