installation and reference guide HP MPIO Full Featured DSM for SAN Virtualization Services Platform 3.01.00 (5697-8031, March 2009)

hpdsm devices all
Syntax: hpdsm devices all
The hpdsm devices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
Total No. of Devices:3
Device Name:HP HSVX700Device#:1
Active Paths:8Serial No:600A0B80001111550000043AE3D6D548
Disk 1Policy:NLB
ALB:N/AP.B.T.L:3.0.0.1
P.B.T.LRTP
HBA
Slot#
StateController Port#Path#
*
3.0.0.1000200112Active00000724C00373-11
3.0.1.1000200152Available00000724C00373-52
3.0.2.1000100032Standby00000724C00519-33
3.0.3.1000100072Standby00000724C00519-74
7.0.0.1000200111Available00000724C00373-15
7.0.1.1000200151Available00000724C00373-56
7.0.2.1000100031Standby00000724C00519-37
7.0.3.1000100071Standby00000724C00519-78
Device Name:HP HSVX700Device#:2
Active Paths:8Serial No:600A0B80001111550000F0C9E3D6D548
Disk 2Policy:SQST
Managing storage devices using the HP MPIO SVSP DSM with the CLI utility26