installation and reference guide HP MPIO Full Featured DSM for MSA1000/1500 (Active-Active) Disk Arrays 3.02.00 (AA-RW8AF-TE, March 2009)

Contents of the
data dump
DescriptionMessageEvent
ID
N/A
A call to a DSM's PathVerify routine to a
pseudo-LUN has failed. This event occurs
during final initialization after PathVerify has
checked whether the device can be reached
through a newly found path.
A Path Verification re-
quest to a device on
pseudo-LUN that is con-
trolled by DSM_name has
failed. This may indicate
a path failure.
20
N/A
MPIO is unable to run through its maintained
list of pseudo-LUNs.
The internal state of
device_object is inconsist-
ent. This indicates poten-
tial failures in this
support.
21
N/A
A failover attempt on a pseudo-LUN has
failed. This indicates that the DSM did not
return a valid path after the call to Invalidate-
Path.
A fail-over on pseudo-LUN
was attempted, however
the attempt failed. The
devices will be removed.
22
N/A
There are no available paths to the pseudo-
LUN. The device has gone into total failure
and will be removed.
All paths have failed.
Pseudo-LUN will be re-
moved.
23
N/A
A PnP request for QueryRemove was rejected
because the device is in the paging, hiber,
or crash dump path state.
A PnP Operation rejected,
as device is not in a
state where the request
can be honored.
24
Path ID used for
resubmission
An issued request from the pseudo-LUN’s
queue failed. This always occurs when the
device is in the process of being removed.
Requests that were queued
to pseudo-LUN have
failed during resubmis-
sion.
25
N/A
One of the following events occurred during
failover: MPIO’s call to the DSMs Invalidate-
Path failed; DSM did not return a new path;
DSM did not return a path when MPIO
called the LBGetPath routine.
DSM_name failed to return
a Path to pseudo-LUN .
32
Bogus Path ID re-
turned by DSM; if
the Path ID =
NULL, the DSM
has failed to re-
turn a path
MPIO is unable to find an operational
device-path pair representation (device info)
for the path that the DSM wants to use for
the I/O to the device.
DSM_name returned a bogus
path to device .
33
DSM ID
MPIO received a DSMNotification call, but
is unable to map the DSM ID to a device.
DSM_name supplied an inval-
id ID for an operation on
notification_type .
35
DSM ID
DSM called DSMSendRequest to have MPIO
send a request on its behalf, but MPIO is
unable to find the pseudo-LUN requested.
An unknown DSM supplied
an invalid ID for an oper-
ation on pseudo-LUN .
36
Multipathing driver event log messages38