installation and reference guide HP MPIO Full Featured DSM for MSA1000/1500 (Active-Active) Disk Arrays 3.02.00 (AA-RW8AF-TE, March 2009)

6. Close the Add/Remove Programs window.
NOTE:
The LUNs may be inaccessible at this time.
7. Reboot the system.
NOTE:
For Windows Server 2008 – Server Core, go to the installation location from the command prompt
and run Launch.exe. Select Remove > Remove allinstalled components, to remove HP MPIO MSA
DSM.
Using silent installation
You can execute the silent installation from the installation location on your computer or from a network
drive. It installs the HP MPIO MSA DSM with little intervention. Silent installation is useful if you are
installing the software on a large number of servers that require software installation.
This section describes the following:
• Installing HP MPIO MSA DSM
• Upgrading HP MPIO MSA DSM
• Removing HP MPIO MSA DSM
• Creating response files for silent mode operations
Syntax:
<install_dir>:\MPInstall\setup.exe /s /f1"C:\setup.iss"
/f2"C:\MPSInstallLog.txt”
The <install_dir> refers to the drive which contains the installation media.
The setup.iss is the response file from which information is taken for silent installation.
The MPSInstallLog.txt file records information about the silent installation.
The ResponseResult section of the MPSInstallLog.txt log file displays the resultant code,
indicating whether or not the silent installation succeeded. An integer value is assigned to the
ResultCode keyname in the ResponseResult section.
Following is the list of common return values along with their descriptions in the ResultCode key:
DescriptionResult Code
Success0
General error–1
Required data not found in the setup.iss file
–3
Not enough memory available–4
File does not exist–5
Installing the HP MPIO Full Featured DSM for MSA1000/1500 (Active-Active) Disk Arrays16