HP MPIO Full Featured DSM for XP family of Disk Arrays 4.00.00 installation and reference guide (AA-RVJ6J-TE, October 2009)

hpdsm devices all
Syntax: hpdsm devices all
The hpdsm devices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
HP OPEN-VTotal No. of Devices:2
Active Paths: 2Device#:1
Disk 1Serial No:50 142460C00
ALB:N/APolicy:NLB
P.B.T.L:3.1.0.0
P.B.T.LRTPHBA Slot#StateController Port#Path#
*
1.0.0.0—7Active3A1
4.0.2.0—6Available3A2
HP OPEN-VDevice#:2
Active Paths: 2Serial No:50 142460C01
Disk 2Policy:SQST-Subset
ALB:N/AP.B.T.L:3.1.0.1
P.B.T.LRTPHBA Slot#StateController Port#Path#
1.0.0.1—7Active3A1
4.0.2.1—6Available3A2
Managing storage arrays using the HP MPIO XP DSM with the CLI utility32