HP MPIO Full Featured DSM for P9000 family of Disk Arrays 4.02.00 installation and reference guide (AA-RVJ6M-TE, October 2010)

NOTE:
• device=all changes the SUBSET STATE for all the devices
• path=all enables or disables subset settings and adds or removes all the available paths to or
from the subset
• Paths in the failed state cannot be added or removed to or from the subset
• hpdsm set device=x subset=remove path=all will cleanup the failed paths and disables
the subset
hpdsm set device path
Syntax: hpdsm set device=x path=y
The hpdsm set device path command changes the preferred path for device x, as shown in
the following example.
NOTE:
Use the hpdsm paths device command to view the available paths for the device.
hpdsm set device=1 path=1
Device Name:HP OPEN-V
Device Serial No.:50 142460C01
Controller Port No.:1A
Change Load Balance policy (y/n)? y
Preferred Path changed. Verify by issuing "hpdsm paths device=<number>" command.
hpdsm cleanup device
Syntax: hpdsm cleanup device=x
Syntax: hpdsm cleanup device=all
The hpdsm cleanup device command allows you to clean up the failed path information for a
specified device x or for all the devices, depending on the input parameters specified, as shown
in the following example.
Example:
hpdsm cleanup device=1
Device Name:HP OPEN-V
HP MPIO Full Featured DSM for P9000 family of Disk Arrays 4.02.00 installation and reference
guide 31