installation and reference guide HP MPIO Full Featured DSM for EVA3000/5000 VCS 4.xxx Disk Arrays 3.02.00 (AA-RW8SH-TE, March 2009)
N5.0.4.2Disk 2
SQST—
Subset
8600508B4000149B50002800000230000
COMPAQ
HSV111_(C) COM-
PAQ
2
N5.0.0.3Disk 3NLB8600508B4000149B50002800000290000
COMPAQ
HSV111_(C) COM-
PAQ
3
Y5.0.3.4Disk 4NLB8600508B4000149B500028000002F0000
COMPAQ
HSV111_(C) COM-
PAQ
4
N5.0.3.5Disk 5SQB8600508B4000149B50002800000350000
COMPAQ
HSV111_(C) COM-
PAQ
5
N3.0.3.6Disk 6SQB8600508B4000149B500028000003B0000
COMPAQ
HSV111_(C) COM-
PAQ
6
N3.0.3.7Disk 7
RR—
Subset
8600508B4000149B50002800000410000
COMPAQ
HSV111_(C) COM-
PAQ
7
N3.0.3.8Disk 8
SQR—
Subset
8600508B4000149B50002800000470000
COMPAQ
HSV111_(C) COM-
PAQ
8
hpdsm devices all
Syntax: hpdsm devices all
The hpdsm devices all command displays the information of the device, followed by their path
information as shown in the following example. If there are no devices present, the following message
is displayed: No devices found.
NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port,
bus, target, and LUN.
Example:
hpdsm devices all
Total No. of Devices:2
Device Name:COMPAQ HSV111_(C)COMPAQDevice#:1
Active Paths: 2Serial No:6005008B400101F6000170000
Disk 1Policy:NLB
ALB:NP.B.T.L:2.0.3.1
Managing storage arrays using the HP MPIO EVA DSM with the CLI utility32