Installation and Reference Guide for HP MPIO Full Featured DSM for XP family of Disk Arrays 3.00.00 (AA-RVJ6F-TE, March 2008)

NOTE:
See hpdsm set device policy for a definition of the policies. The P.B.T.L. column shows the device port ,
bus, target, and LUN.
Example:
hpdsm devices all
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
1
HP OPEN-V
50 02747033C 2
SQST
Disk 1 1.0.0.0
N/A
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1 3A Active
7
—
1.0.0.0
2 3A Active 6
—
4.0.2.0
Device#
Device Name Serial No.
Active
Paths
Policy
Disk#
P.B.T.L ALB
2
HP OPEN-V
50 02747033D 2
SQST
Disk 2 4.0.2.1
N/A
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
1
3A Active
7
—
1.0.0.1
2 3A Active 6
—
4.0.2.1
hpdsm paths device
Syntax: hpdsm paths device=1
The hpdsm paths device command displays information about the paths available for device 1,as
shown in the following example.
NOTE:
The P.B.T.L. column shows the device port, bus, target, and L UN.
hpdsm paths device=1
Path# Controller Port#
State
HBA Slot#
RTP P.B.T.L
11A
Active 3
—
3.1.0.0
2 1A Active 3
—
4.1.0.0
hpdsm set
device policy
Syntax: hpdsm set device=1 policy=policy
Syntax: hpdsm set device=all policy=policy
28
Managing storage arrays using the HP MPIO XP DSM with the CLI utility