Installation and Reference Guide for HP MPIO Full Featured DSM for XP family of Disk Arrays 3.00.00 (AA-RVJ6F-TE, March 2008)

Result Code
Description
0Success
–1
General error
–3
Required data not found in the setup.iss file
–4
Not enough memor y available
–5
File does not exist
–6
Cannot write to the response file
–7
Unable to writ
etothelogfile
–8
Invalid path to the InstallShield Silent response ( .iss) file
–51
Cannot create the specifi ed folder
–52
Cannot access
the specified file or folder
NOTE:
The C: in /f1C: and /f2C: r efers to a local drive on the system or a network drive which is used
to obtain the r
esponse file and write the MPSInstallLog.txt (provided there is write permission
in the directory).
For 32 bit systems: <Default_Target_Dir> = C:\Program Files\Hewlett-Packard\HP
MPIO DSM\XP DSM
For 64 bit systems: <Default_Target_Dir> = C:\Program Files (x86)\Hewlett-
Packard\HP M
PIO DSM\XP DSM
<User_Targe
t_Dir>= a directory on the system on which the new installation is to be done or
the director
yofanexistinginstallation.
You must enclose the paths to the response file and the log file, which records the information about
the silent in
stallation in quotes ("").
Installing HP MPIO XP DSM
To perform a silent installation of HP MPIO XP DSM, complete the steps below:
1. Make a copy of the new.iss fi le in the installation kit.
2. Rename this copy of the file as setup.iss
3. Choose one of the following options:
• To install into the default directory for 64 bit sys tems, in lines 27 and 32 of the setup.iss
file, replace C:\Program Files\Hewlett-Packard\HP MPIO DSM\XP DSM with
C:\Program Files (x86)\Hewlett-Packard\HP MPIO DSM\XP DSM.
• To install into the user specified directory for both 32 and 64 bit systems, in lines 27 and
32 of the setup.iss file, replace szDir = <Default_Target_Dir> with szDir =
<User_Target_Dir>.
4. Choose one of the following to install HP MPIO XP DSM for 64 bit systems: Choose one of
the following options:
• To install the Microsoft MPIO Framework component along with the DSM component, use the
renamed default setup.iss file.
• To install only the DSM component (when the Microsoft MPIO Framework already exists on
your system) , edit the renamed default setup.iss file as follows:
a. In line 34, replace Component-count=2 with Component-count=1.
b. Remove line 35.
c. In line 36, replace Component-1=DSM with Component-0=DSM.
18
Installing the HP MPIO Full Featured DSM for XP family of Disk Arrays